Amprobe ACD-14-FX Clamp-On-Multimeter Manual do Utilizador descarregar pdf (Página 15)

Battery replacement

The meter uses 2 standard 3V alkaline button batteries (ANSI/NEDA-5004LC, IEC-CR2030).

The lower battery is used for the slide-switch functions, and the upper battery is used for

the upper display ACA function separately.

Low Battery Indication: When the battery voltage drops below approx. 2.4V, a battery

symbol will appear in the upper right corner of the LCD display, indicating that the

battery needs replacing.

To replace the batteries, loosen the two screws from the case bottom and remove the

bottom case. Slide the battery out the side of the holder (see example below) and replace

with a new battery (observe polarity). Replace the bottom case. Note: Take care to insure

that the two (2) springs (located near the lower battery) line up with the speaker in the

rear cover.

Re-fasten the screws.

1 2 ... 10 11 12 13 14 15 16 17 18 19

Sem comentários

Amprobe ACD-14-FX Clamp-On-Multimeter Manual do Utilizador Página 15