Amprobe IR-450 Instruções de Operação Página 1

Users ManualIR-450Infrared Thermometer / Laser Pointer / Flashlight 99 Washington Street Melrose, MA 02176 Phone 781-665-1400Toll Free 1-800-517-8431

5Use the unit at around 30cm to get the best measurement accuracy.At longer distances, the target area shall be larger than the distance divided by 8.

6 Allow time for the unit to adapt to the change of ambient temperatures from the user’s pocket to environmental ambient.2. The unit cannot take mea

73. Not recommended for use in measuring shiny or polished metal surfaces (stainless steel, aluminum, etc.). See Emissivity.4. Steam, dust, smoke, etc

8Repeatability ±1°C or ±0.5% of reading, whichever is greater.Display Hold 10 sElectrical SupplyInternally powered by 1 x AAA 1.5 Alkaline, LR03 batte

9MAINTENANCE AND REPAIRLens Cleaning: Blow off loose particles using clean compressed air. Gently brush remaining debris away with a brush. Carefully

10BATTERY REPLACEMENTPlease replace the battery when “Battery indicator” is flashing on display.When battery is replaced / installed, the unit will go

IR-450 Infrared Thermometer / Laser Pointer / FlashlightUsers Manual4240687A©2012 Amprobe.All rights reserved. Printed in TaiwanEnglish

Limited Warranty and Limitation of LiabilityYour Amprobe product will be free from defects in material and workmanship for one year from the date of p

IR-450 Infrared Thermometer / Laser Pointer / Flashlight1) Laser2) Flash light3) Display4) Flashlight button5) On button / Test button6) Battery cove

CONTENTSSYMBOLS ... 1UNPACKING AND INSPECTION ...

1SYMBOLSCaution! Refer to the explanation in this ManualLaser light: Do not stare into laser beamBatteryConform to relevant Australian standardsC

2CautionsThe unit should be protected from the following,• EMF (electro-magnetic elds) from arc welders and induction heaters• Static electricity•

3OPERATING INSTRUCTIONSPower On / OffAuto Power OffThe IR-450 will power down after not being used for 3 minutes.Auto HoldThe unit will hold the readi

4Make sure that the target is larger than the unit‘s spot size. The smaller the target, the closer you should be to it. The minimum measurement area i